Separation mechanism of nortriptyline and amytriptyline in RPLC

The single and the competitive equilibrium isotherms of nortriptyline and amytriptyline were acquired by frontal analysis (FA) on the C18- bonded discovery column, using a 28/72 (v/v) mixture of acetonitrile and water buffered with phosphate (20 mM, pH 2.70). The adsorption energy distributions (AED) of each compound were calculated from the raw adsorption data. Both the fitting of the adsorption data using multi-linear regression analysis and the AEDs are consistent with a trimodal isotherm model. The single-component isotherm data fit well to the tri-Langmuir isotherm model. The extension to a competitive two-component tri-Langmuir isotherm model based on the best parameters of the single-component isotherms does not account well for the breakthrough curves nor for the overloaded band profiles measured for mixtures of nortriptyline and amytriptyline. However, it was possible to derive adjusted parameters of a competitive tri-Langmuir model based on the fitting of the adsorption data obtained for these mixtures. A very good agreement was then found between the calculated and the experimental overloaded band profiles of all the mixtures injected.     

Targeting of Single‐Stranded Oligonucleotides through Metal‐Induced Cyclization of Short Complementary Strands

A new strategy to cyclize short synthetic oligonucleotides on DNA or RNA target strands is described. The approach is based on metal‐templated cyclization of short synthetic oligonucleotides conjugated with two chelating 2,2′ : 6′,2′′‐terpyridine (Tpy) moieties at their 3′‐ and 5′‐ends. Cyclization after metal addition (Zn²⁺, Fe²⁺) was demonstrated by means of thermal‐denaturation experiments, MALDI‐Q‐TOF‐MS, and gel electrophoresis (PAGE). 1D‐ and 2D‐NMR Experiments were performed to analyze the association of complementary strands after metal‐mediated cyclization. Our protocol allows the efficient circularization of synthetic oligonucleotides. Thereby, the hybridization on a complementary strand was more efficient with an RNA target strand and a 2′‐O‐methylated circularized oligomer.     

Diasteroselective synthesis of new spiropiperidine scaffolds from the CN(R,S) building block

A methodology allowing the construction of spiropiperidine scaffolds similar to those found in naturally occurring alkaloids has been developed. This approach begins with the well-established CN(R,S) strategy, the spiro-center being built by way of an intramolecular attack of a nitrile function by an organolithium species obtained by a halogen/lithium exchange reaction mediated by either t-BuLi or lithium naphthalenide.     

Early reactions of light-induced protochlorophyllide and chlorophyllide transformations analyzed in vivo at room temperature with a diode array spectrofluorometer

The steps of protochlorophyllide (Pchlide) photoreduction and subsequent chlorophyllide (Chlide) transformations which occur in the seconds to minutes time-scale were studied using a diode array spectrofluorometer in dark-grown barley leaves. The intensity of the excitation light was varied between 3 and 2,500 micromol m(-2) s(-1) and a series of fluorescence spectra were recorded at room temperature in the seconds and minutes time scales. In certain experiments, 77-K emission spectra were measured with the same equipment. The high quality of the spectra allowed us to run spectral resolution studies which proved the occurrence, at room temperature, of multiple Pchlide and Chlide forms found previously in 77-K spectra. The comparison of the 77-K and room-temperature spectra showed that the fluorescence yields of the nonphotoactive 633-nm Pchlide form and of the Chlide product emitting at 678 nm were temperature independent. The fluorescence intensity of aggregated NADPH-pigment-POR complexes (photoactive 656-nm Pchlide and 693-nm Chlide forms) were strongly increased at 77 K, while that of the NADP(+)-Chlide-POR (684-686-nm Chlide form) was much less affected by temperature. Information was obtained also about the dynamics of the transformation of pigment forms in the light at different photon densities. At low light intensities, the phototransformation of the 642-644-nm Pchlide form was faster than that of the 654-656-nm form. The relative amplitudes of Gaussian components related to different Chlide forms found after exposure to a constant amount of photons strongly depended on the light intensity used. Strong quenching of all Chlide components occurred upon prolonged exposure to high intensity light. These effects are discussed by considering the interconversion processes between different forms of the pigment-protein complexes, their relative fluorescence yields and energy migration processes.     

Overloaded gradient elution chromatography on heterogeneous adsorbents in reversed-phase liquid chromatography

Overloaded band profiles of phenol were measured on a C18-Kromasil column in gradient elution conditions. The mobile phase used was a mixture of methanol and water. The volume fraction of methanol was allowed to vary between 0 and 0.5. A general adsorption model, which expresses the amount of phenol adsorbed q* as a function of both its concentration C and the composition phi of the organic modifier (methanol) in the mobile phase, was empirically derived from previous independent adsorption experiments based on frontal analysis (FA) and frontal analysis by the characteristic point (FACP). Accordingly, the general model was an extension of the simplest heterogeneous model, the Bilangmuir model, to non-isocratic conditions. The low-energy sites followed the classical linear solvent strength model (LSSM), but not the high-energy sites whose saturation capacity linearly decreased with phi. The general model was validated by comparing the experimental and simulated band profiles in gradient elution conditions, in linear and non-linear conditions, as well. The band profiles were calculated by means of the equilibrium-dispersive model of chromatography with a finite difference algorithm. A very good agreement was observed using steps gradient (delta phi) from 0 to 50% methanol and gradient times t(g) of 20, 25, 30, 40, 60, 80 and 100 min. The agreement was still excellent for steps gradient from 5 to 45% (t(g) = 25 min), 5 to 35% (t(g) = 50 min), 5 to 25% (t(g) = 50 min) and 5 to 15% (t(g) = 50 min). Significative differences appeared between experience and simulation when the slope of the gradient (delta phi/t(g)) became too strong beyond 3.3% methanol per minute. This threshold value probably mirrored the kinetic of arrangement of the G18-bonded chains when the methanol content increased in the mobile phase. It suggested that the chromatographic system was not in a full thermodynamic equilibrium state when very steep mobile phase gradients were applied.     

Cyclic organohydroborate complexes of metallocenes: VIII. Triphenylsiloxy derivatives of Group IV organometallic systems, Cp2M(OSiPh3)X (M=Ti, Zr, Hf; X=Cl, {(μ-H)2BC8H14})

Group IV metallocene triphenylsiloxy chlorides, Cp₂MCl(OSiPh₃) (1, M=Ti; 2, M=Zr; 3, M=Hf), and cyclic organohydroborates, Cp₂M(OSiPh₃){(μ-H)₂BC₈H₁₄} (4, M=Zr; 5, M=Hf), were synthesized and characterized. The new hafnocene chloride derivative 3 was obtained by treating Cp₂HfCl₂ with triphenylsilanol and piperidine. The 18-electron cyclic organohydroborates 4 and 5 were afforded by reacting 2 and 3 with K[H₂BC₈H₁₄], the potassium salt of the 9-BBN dimer. Reaction of 1 with K[H₂BC₈H₁₄] causes reduction of the Ti(IV) center and produces the well-known Ti(III), 17-electron, paramagnetic dimer [Cp₂Ti(μ-Cl)₂TiCp₂] (6). Single-crystal X-ray diffraction structures of 3, 4, 5, and 6 were determined.     

Effect of the ionic strength of salts on retention and overloading behavior of ionizable compounds in reversed-phase liquid chromatography I. XTerra-C18

The influence of the salt concentration (potassium chloride) on the retention and overloading behavior of the propranolol cation (R'-NH2+ -R) on an XTerra-C18 column, in a methanol:water solution, was investigated. The adsorption isotherm data were first determined by frontal analysis (FA) for a mobile phase without salt (25% methanol, v/v). It was shown that the adsorption energy distribution calculated from these raw adsorption data is bimodal and that the isotherm model that best accounts for these data is the bi-Moreau model. Assuming that the addition of a salt into the mobile phase changes the numerical values of the parameters of the isotherm model, not its mathematical form, we used the inverse method (IM) of chromatography to determine the isotherm with seven salt concentrations in the mobile phase (40% methanol, v/v; 0, 0.002, 0.005, 0.01, 0.05, 0.1 and 0.2 M). The saturation capacities of the model increase, q(s,1) by a factor two and q(s,2) by a factor four, with increasing salt concentration in the range studied while the adsorption constant b1 increases four times and b2 decreases four times. Adsorbate-adsorbate interactions vanish in the presence of salt, consistent with results obtained previously on a C18-Kromasil column. Finally, besides the ionic strength of the solution, the size, valence, and nature of the salt ions affect the thermodynamic as well as the mass transfer kinetics of the adsorption mechanism of propranolol on the XTerra column.     

On pathwise behavior of multiserver queues

In this paper, by exploiting recent results on the pathwise behavior of the workload process in single server, work conserving queues of theG/G/1/ type, we show that the workload of multiserver, work conserving queues ofG/G/m/ (m<) (andG/G/) queues satisfies an o(t) growth condition, provided that the time average of the work brought into the system is less thanm form < (and finite form=).     

Noncovalent functionalization of multi-walled carbon nanotubes by pyrene containing polymers

Multi-walled carbon nanotubes (MWNTs) have been solubilized in water and in various organic solvents by noncovalent side-wall functionalization by pyrene containing polymers.     

Synthesis of new crosslinkable co-polymers containing a push-pull zinc porphyrin for non-linear optical applications

In this paper, the synthesis of a crosslinkable co-polymer containing new push-pull arylethynyl zinc porphyrins is described. The synthesis of porphyrin chromophores, analogous to Therien's porphyrin (J. Am. Chem. Soc.1996, 118, 1497-1503) functionalized with a methacrylic polymerizable group and a carboxylic acid crosslinking group was achieved with a new synthetic procedure leading to a higher overall yield compared to what was previously reported in the literature for similar and simpler structures. Radical copolymerization of the porphyrin chromophore with glycidyl methacrylate has then been carried out with success. This work opens a perspective on the possibility to integrate porphyrinic chromophore with high first-order molecular quadratic hyperpolarizability coefficient in opto-electronic devices.